User's Manual

Chapter 4 Client Mode
WAP3205 User’s Guide
43
The following table describes the labels in this screen.
4.8 WPS Screen
Use this screen to enable Wi-Fi Protected Setup (WPS) on the WAP3205. Go to
Configuration > Wireless LAN > WPS to open the following screen.
Figure 17 Client Mode: WLAN > WPS
Table 11 Client Mode: WLAN > Site Survey
LABEL DESCRIPTION
Station Site Survey
# Select a wireless device and click Add Profile to open a configuration
screen where you can add the selected wireless device to a profile and
then enable it.
SSID This displays the SSID of the wireless device.
indicates the wireless device is added to an activated profile and the
WAP3205 is connecting to it.
BSSID This displays the MAC address of the wireless device.
Signal
Strength
This displays the strength of the wireless signal. The signal strength
mainly depends on the antenna output power and the distance between
your WAP3205 and this device.
Channel This displays the channel number used by this wireless device.
Encryption This displays the data encryption method used by this wireless device.
Authentication This displays the authentication method used by this wireless device.
Network Type This displays the network type (Infrastructure or Ad Hoc) of this
wireless device.
Rescan Click this button to search for available wireless devices within
transmission range and update this table.
Add Profile Select a wireless device and click this button to add it to a profile.