User's Guide

Chapter 11 Wireless LAN
EMG3435-Q20A User’s Guide
106
The following table describes the labels in this screen.
11.5 MAC Filte r Sc re e n
The MAC filter screen allows you to configure the EMG3435-Q20A to give exclusive access to devices
(Allo w) or exclude devices from accessing the EMG3435-Q20A (De ny). Every Ethernet device has a
unique MAC (Media Access Control) address. The MAC address is assigned at the factory and consists
of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know the MAC
address of the devices to configure this screen.
To change your EMG3435-Q20A’s MAC filter settings, click Expe rt Mo de > Wire le ss > MAC Filte r. The
screen appears as shown.
Table 32 Expert Mode > Wireless > Guest Wireless > Guest Wireless Setup: Edit
LABEL DESCRIPTIO N
Active Select this to activate the SSID profile.
Name (SSID) The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is associated.
Enter a descriptive name (up to 32 printable characters found on a typical English language
keyboard) for the wireless LAN.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station cannot obtain
the SSID through scanning using a site survey tool.
Intra-BSS Traffic
Blocking
A Basic Service Set (BSS) exists when all communications between wireless clients or between a
wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is enabled, wireless
clients can access the wired network and communicate with each other. When Intra-BSS is
disabled, wireless clients can still access the wired network but cannot communicate with each
other.
WMM QoS Check this to have the EMG3435-Q20A automatically give a service a priority level according
to the ToS value in the IP header of packets it sends.
WMM QoS (Wifi MultiMedia Quality of Service) gives high priority to voice and video, which
makes them run more smoothly.
Enable
Bandwidth
Management for
Guest WLAN
Select this to turn on bandwidth management for the Guest Wi-Fi network.
Maximum
Bandwidth
Enter a number to specify maximum bandwidth the Guest Wi-Fi network can use.
Security Mode Select WPA- PSK or WPA2- PSK to add security on this wireless network. The wireless clients which
want to associate to this network must have same wireless security settings as this device. After
you select to use a security, additional options appears in this screen. See
Section 11.3 on page
100
for detailed information on different security modes. Or you can select No Se c urity to allow
any client to associate this network without authentication.
Note: If the WPS function is enabled (default), only No Se c urity and WPA2- PSK are
available in this field.
Apply Click A pply to save your changes back to the EMG3435-Q20A.
Cancel Click Ca nc e l to reload the previous configuration for this screen.