User's Guide

Chapter 15 Maintenance
EMG3435-Q20A User’s Guide
147
Fig ure 99 Expert Mode > Maintenance > General
The following table describes the labels in this screen.
15.4 Pa sswo rd Sc re e n
It is strongly recommended that you change your EMG3435-Q20A's password.
If you forget your EMG3435-Q20A's password (or IP address), you will need to reset the device. See
Section 15.8 on page 152 for details.
Click Expe rt Mo de > Ma inte na nc e > Pa sswo rd. The screen appears as shown.
Fig ure 100 Expert Mode > Maintenance > Password
The following table describes the labels in this screen.
Table 53 Expert Mode > Maintenance > General
LABEL DESCRIPTION
System Name System Name is a unique name to identify the EMG3435-Q20A in an Ethernet network.
Domain Name Enter the domain name you want to give to the EMG3435-Q20A.
Administrator
Inactivity Timer
Type how many minutes a management session can be left idle before the session times out.
The default is 5 minutes. After it times out you have to log in with your password again. Very
long idle timeouts may have security risks. A value of "0" means a management session
never times out, no matter how long it has been left idle (not recommended).
Apply Click Apply to save your changes back to the EMG3435-Q20A.
Cancel Click Ca nc e l to begin configuring this screen afresh.
Table 54 Expert Mode > Maintenance > Password
LABEL DESCRIPTIO N
Old Password Type the default password or the existing password you use to access the system in this
field.
New Password Type your new system password (up to 30 characters). Note that as you type a password,
the screen displays an asterisk (*) for each character you type.
Retype to Confirm Type the new password again in this field.