User's Guide

Chapter 15 Maintenance
EMG3435-Q20A User’s Guide
156
The following table describes the labels in this screen.
15.11 Lo g Sc re e n
The Web Configurator allows you to look at all of the EMG3435-Q20A’s logs in one location.
You can configure which logs to display in the Log screen. Select the logs you wish to display. Click
Apply to save your settings. Click Ca nc e l to start the screen afresh.
Use this screen to see the logged messages for the EMG3435-Q20A. The log wraps around and deletes
the old entries after it fills. Select what logs you want to see from the Displa y drop list. The log choices
depend on your settings above this screen. Click Re fre sh to renew the log screen. Click C le a r Lo g to
delete all the logs.
Table 59 Expert Mode > Maintenance > Remote Management > Wake On LAN
LABEL DESCRIPTIO N
Wake On LAN over WAN Settings
Enable Wake On
LAN over WAN
Select Ena ble to have the EMG3435-Q20A forward a WoL “Magic Packet” to all devices on the
LAN if the packet comes from the WAN or remote network and uses the port number specified
in the Port field. A LAN device whose hardware supports Wake on LAN then will be powered on
if it is turned off previously.
Port Type a port number from which a WoL packet is forwarded to the LAN.
Wake On LAN
Wake MAC
Address
This field displays the hostname and MAC address of the LAN device by default. Otherwise,
select Use r d e fine to enter the MAC Address of the device on the network that will be turned
on.
A MAC address consists of six hexadecimal character pairs.
Start Click this to have the EMG3435-Q20A generate a WoL packet and forward it to turn the
specified device on.
A screen pops up displaying MAC address error if you input the MAC address incorrectly.
Apply Click Apply to save your changes back to the EMG3435-Q20A.
Cancel Click Ca nc e l to begin configuring this screen afresh.