User's Guide
Table Of Contents
- EMG3435-Q20A
- User’s Guide
- Technical Reference
- Status
- WAN
- Wireless LAN
- LAN
- Applications
- Security
- Maintenance
- Troubleshooting
- Customer Support
- Setting Up Your Computer’s IP Address
- Common Services
- Legal Information
- Index
Chapter 5 Easy Mode
EMG3435-Q20A User’s Guide
33
The following table describes the labels in this screen.
5.6.3 Pa re nta l C ontro l
Use this screen to view the parental control rules configured on the EMG3435-Q20A. See
Section 13.2 on
page 119
for how to enable and configure parental control rules.
Fig ure 25 Easy Mode: Parental Control
The following table describes the labels in this screen.
Table 11 Easy Mode: Guest Wi-Fi
LABEL DESCRIPTIO N
Wireless Radio Choose whether you want to apply the wireless settings to the 2.4G Hz or 5G Hz wireless
radio.
Network Name
(SSID)
The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is
associated. Enter a descriptive name (up to 32 printable characters found on a typical
English language keyboard) for the guest wireless network.
Security Mode Select WPA2- PSK to enable data encryption. Or select No Se c urity to allow wireless clients to
communicate with the EMG3435-Q20A without any data encryption.
Password This field appears when you choose WPA2- PSK as the security mode.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Verify Password Type the password again to confirm.
Cancel Click Ca nc e l to reload the previous configuration for this screen.
Apply Click A pply to save your changes back to the EMG3435-Q20A.
Table 12 Easy Mode: Parental Control
LABEL DESCRIPTIO N
Status This indicates whether the rule is active or not.
A yellow bulb signifies that this rule is active. A gray bulb signifies that this rule is not active.
User Name This shows the name of the user to which this rule applies.
Schedule This shows whether the user is allowed to access the Internet (Allo w) or not (Blo c k).
Bonus If the user is currently not permitted to access the Internet, you can click the Bo nus to allow
access for a specified period of time. A screen then displays allowing you to set how long (in
minutes) the user is allowed to access the Internet.
This button is grayed out if the user is now able to access the Internet.
Remaining time This field displays the amount of Internet access time that remains for each user before the
EMG3435-Q20A blocks the user from accessing the Internet.
No ne means there is no extra Internet access time.