User's Guide

Chapter 10 Quality of Service (QoS)
EX3510-B0 User’s Guide
154
The following table describes the labels in this screen.
Table 49 Classification Setup: Add/Edit
LABEL DESCRIPTION
Step1: Class Configuration
Active Click this switch to enable or disable the classifier. When the switch turns blue , the function
is enabled. Otherwise, it is not.
Class Name Enter a descriptive name of up to 15 printable English keyboard characters, not including
spaces.
Classification
Order
Select an existing number for where you want to put this classifier to move the classifier to the
number you selected after clicking Apply.
Select Last to put this rule in the back of the classifier list.
Step2: Criteria Configuration
Basic
From Interface If you want to classify the traffic by an ingress interface, select an interface from the From
Interface drop-down list box.
Ether Type Select a predefined application to configure a class for the matched traffic.
If you select IP, you also need to configure source or destination MAC address, IP address, DHCP
options, DSCP value or the protocol type.
If you select 802.1Q, you can configure an 802.1p priority level.
Source
Address Select the check box and enter the source IP address in dotted decimal notation. A blank
source IP address means any source IP address.
Subnet Mask Enter the source subnet mask.
Port Range If you select TCP or UDP in the IP Protocol field, select the check box and enter the port
number(s) of the source.
MAC Select the check box and enter the source MAC address of the packet.
MAC Mask Type the mask for the specified MAC address to determine which bits a packet’s MAC address
should match.
Enter “f” for each bit of the specified source MAC address that the traffic’s MAC address should
match. Enter “0” for the bit(s) of the matched traffic’s MAC address, which can be of any
hexadecimal character(s). For example, if you set the MAC address to 00:13:49:00:00:00 and the
mask to ff:ff:ff:00:00:00, a packet with a MAC address of 00:13:49:12:34:56 matches this criteria.
Exclude Select this option to exclude the packets that match the specified criteria from this classifier.
Destination
Address Select the check box and enter the source IP address in dotted decimal notation. A blank
source IP address means any source IP address.
Subnet Mask Enter the source subnet mask.
Port Range If you select TCP or UDP in the IP Protocol field, select the check box and enter the port
number(s) of the source.
MAC Select the check box and enter the source MAC address of the packet.
MAC Mask Type the mask for the specified MAC address to determine which bits a packet’s MAC address
should match.
Enter “f” for each bit of the specified source MAC address that the traffic’s MAC address should
match. Enter “0” for the bit(s) of the matched traffic’s MAC address, which can be of any
hexadecimal character(s). For example, if you set the MAC address to 00:13:49:00:00:00 and the
mask to ff:ff:ff:00:00:00, a packet with a MAC address of 00:13:49:12:34:56 matches this criteria.
Exclude Select this option to exclude the packets that match the specified criteria from this classifier.
Others