Users Manual Part 1

Chapter 6 Broadband
PX7511-B0 User’s Guide
83
6.2.1.2 Bridge Mode
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon next to the
connection you want to configure. The following example screen displays when you select the Bridge
mode.
Figure 46 Network Setting > Broadband > Add/Edit New WAN Interface (Bridge Mode)
Select Manually Configured if you have the IPv4 address of the relay server. Otherwise, select
Automatically configured by DHCPC to have the Zyxel Device detect it automatically through
DHCP.
The Automatically configured by DHCPC option is configurable only when you set the method of
encapsulation to IPoE.
Service Provider
IPv6 Prefix
Enter an IPv6 prefix for tunneling IPv6 traffic to the ISP’s border relay router and connecting to
the native IPv6 Internet.
IPv4 Mask
Length
Enter the subnet mask number (1~32) for the IPv4 network.
Border Relay
IPv4 Address
When you select Manually Configured, specify the relay server’s IPv4 address in this field.
IPv6 IA_PD and IA_NA (This is available only when you select IPv4 IPv6 DualStack or IPv6 Only in the IPv4/IPv6 Mode
field.)
Prefix
Delegation
Click this switch to use DHCP PD (Prefix Delegation) which enables the Zyxel Device to pass the
IPv6 prefix information to its LAN hosts. The hosts can then use the prefix to generate their IPv6
addresses.
When the switch goes to the right , the function is enabled. Otherwise, it is disabled.
IPv6 Address
From DHCPv6
Server
Click this switch to obtain an IPv6 address from a DHCPv6 server. The IP address assigned by a
DHCPv6 server has priority over the IP address automatically generated by the Zyxel Device
using the IPv6 prefix from a Router Advertisement (RA).
When the switch goes to the right , the function is enabled. Otherwise, it is disabled.
Cancel Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
Table 17 Network Setting > Broadband > Add/Edit New WAN Interface (Routing Mode)
LABEL DESCRIPTION