Operation Manual

Chapter 8 Quality of Service (QoS)
eircom F1000 Modem User’s Guide
147
8.7 The QoS Monitor Screen
This screen is available only when you set a rate limit for a WAN queue in the Queue Setup screen
and the WAN interface is connected. Use this screen to monitor the traffic statistics for both the
WAN and LAN interfaces. To view the Device’s QoS packet statistics, click Network Setting > QoS
> Monitor. The screen appears as shown.
Figure 80 Network Setting > QoS > Monitor
Conforming
Action
Specify what the Device does for packets within the committed rate and burst size (green-
marked packets).
• Pass: Send the packets without modification.
• DSCP Mark: Change the DSCP mark value of the packets. Enter the DSCP mark value to
use.
Non-
Conforming
Action
Specify what the Device does for packets that exceed the excess burst size or peak rate and
burst size (red-marked packets).
• Drop: Discard the packets.
• DSCP Mark: Change the DSCP mark value of the packets. Enter the DSCP mark value to
use. The packets may be dropped if there is congestion on the network.
Available Class
Selected Class
Select a QoS classifier to apply this QoS policer to traffic that matches the QoS classifier.
Highlight a QoS classifier in the Available Class box and use the > button to move it to the
Selected Class box.
To remove a QoS classifier from the Selected Class box, select it and use the < button.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 50 Policer Setup: Add/Edit
LABEL DESCRIPTION