Operation Manual

GS1920 Series User’s Guide
28
CHAPTER 3
Hardware Panels
This chapter describes the front panel and rear panel of the Switch and shows you how to make the
hardware connections.
3.1 Front Panel
The following figures show the front panels of the Switch.
Figure 7 Front Panel: GS1920-24
Figure 8 Front Panel: GS1920-24HP
Figure 9 Front Panel: GS1920-48
Figure 10 Front Panel: GS1920-48HP
3.1.1 Gigabit Ethernet Ports
The Switch has 1000Base-T auto-negotiating, auto-crossover Ethernet ports. In 10/100/1000 Mbps
Gigabit, the speed can be 10 Mbps, 100 Mbps or 1000 Mbps and the duplex mode can be half duplex
or full duplex.
An auto-negotiating port can detect and adjust to the optimum Ethernet speed (10/100/1000 Mbps)
and duplex mode (full duplex or half duplex) of the connected device.
An auto-crossover (auto-MDI/MDI-X) port automatically works with a straight-through or crossover
Ethernet cable.
Four 1000Base-T Ethernet ports are paired with an SFP slot to create a dual personality interface. The
Switch uses up to one connection for each SFP and 1000Base-T Ethernet pair. The SFP slots have priority
over the Gigabit ports. This means that if an SFP slot and the corresponding GbE port are connected at
the same time, the GbE port will be disabled.