Operation Manual

Chapter 33 Link Layer Discovery Protocol (LLDP)
GS1920 Series User’s Guide
284
33.7 LLDP-MED Configuration
Click Advanced Application > LLDP > LLDP-MED Configuration to display the screen as shown next.
Figure 205 Advanced Application > LLDP > LLDP-MED Configuration
Port VLAN ID Select the check box(es) to enable or disable the sending of IEEE 802.1 Port VLAN ID TLVs on
the port(s). All check boxes in this column are enabled by default.
Dot3 TLV
Link
Aggregation
Select the check box(es) to enable or disable the sending of IEEE 802.3 Link Aggregation TLVs
on the port(s).
MAC/PHY Select the check box(es) to enable or disable the sending of IEEE 802.3 MAC/PHY
Configuration/Status TLVs on the port(s). All check boxes in this column are enabled by
default.
Max Frame Size Select the check box(es) to enable or disable the sending of IEEE 802.3 Max Frame Size TLVs
on the port(s).
Power Via MDI Note: For PoE models only. The Power Via MDI TLV allows network management to advertise
and discover the MDI power support capabilities of the sending port on the remote device.
• Port Class
• MDI Supported
•MDI Enabled
•Pair Controlable
•PSE Power Pairs
•Power Class
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 137 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL DESCRIPTION