Operation Manual

Chapter 35 Static Route
GS1920 Series User’s Guide
299
Figure 213 IP Application > Static Routing
To enable IPv4 static route, configure the static route settings in the IP Application > Static Routing > IPv4
Static Route screen.
35.3 IPv4 Static Route
Click IP Application > Static Routing > IPv4 Static Route in the navigation panel to display the screen as
shown.
Figure 214 IP Application > Static Routing > IPv4 Static Route
The following table describes the related labels you use to create a static route.
Table 145 IP Application > Static Routing > IPv4 Static Route
LABEL DESCRIPTION
Active This field allows you to activate/deactivate this static route.
Name Enter a descriptive name (up to 10 printable ASCII characters) for identification purposes.
Destination IP
Address
This parameter specifies the IP network address of the final destination.
IP Subnet Mask Enter the subnet mask for this destination. Routing is always based on network number. If you
need to specify a route to a single host, use a subnet mask of 255.255.255.255 in the subnet mask
field to force the network number to be identical to the host ID.
Gateway IP
Address
Enter the IP address of the gateway. The gateway is an immediate neighbor of your Switch that
will forward the packet to the destination. The gateway must be a router on the same segment
as your Switch.