Operation Manual

Chapter 39 Maintenance
GS1920 Series User’s Guide
323
39.2.1 Erase Running-Configuration
Follow the steps below to reset the Switch back to the Zyxel default configuration settings.
1 In the Maintenance screen, click the Click Here button next to Erase Running-Configuration to clear all
Switch configuration information you configured and return to the Zyxel default configuration settings.
2 Click OK to reset all Switch configurations to the Zyxel default configuration settings.
Figure 234 Erase Running-Configuration: Confirmation
3 In the web configurator, click the Save button in the top of the screen to make the changes take effect.
If you want to access the Switch web configurator again, you may need to change the IP address of
your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1).
39.2.2 Save Configuration
Click Config 1 to save the current configuration settings to Configuration 1 on the Switch. These
configurations are set up according to your network environment.
Click Config 2 to save the current configuration settings to Configuration 2 on the Switch. These
configurations are set up according to your network environment.
Click Custom Default to save the current configuration settings to a customized default file on the
Switch.
Note: Config 2 will be reserved for the custom default feature when you activate it. You are
no longer able to save the Running-config to Config 2 or reboot from it.
Note: If a customized default file was not saved, clicking Custom Default loads the Config 2
file on the Switch.
Note: If a Config 2 file was not saved, nor was a customized default file, clicking Custom
Default loads the Zyxel factory default configuration settings on the Switch.
Alternatively, click Save on the top right-hand corner in any screen to save the configuration changes
to the current configuration.
Note: Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.