Operation Manual

Chapter 8 Basic Setting
GS1920 Series User’s Guide
62
CHAPTER 8
Basic Setting
8.1 Overview
This chapter describes how to configure the System Info, General Setup, Switch Setup, IP Setup, Port
Setup, PoE, Interface Setup and IPv6 screens.
8.1.1 What You Can Do
• Use the System Info screen (Section 8.2 on page 62) to check the firmware version number.
• Use the General Setup screen (Section 8.3 on page 64) to configure general settings such as the
system name and time.
• Use the Switch Setup screen (Section 8.5 on page 67) to choose your VLAN type, set the GARP timers
and assign priorities to queues.
• Use the IP Setup screen (Section 8.6 on page 68) to configure the Switch IP address, default gateway
device, and the management VLAN ID.
• Use the Port Setup screen (Section 8.7 on page 70) to configure Switch port settings.
• Use the PoE Status screens (Section 8.8 on page 72) to view the current amount of power that PDs are
receiving from the Switch and set the priority levels for the Switch in distributing power to PDs. This
screen is available for PoE model(s) only.
• Use the Interface Setup screens (Section 8.9 on page 76) to configure Switch interface type and
interface ID settings.
• Use the IPv6 screens (Section 8.10 on page 77) to view IPv6 status and IPv6 configuration.
• Use the DNS screen (Section 8.11 on page 87) to configure the default domain name server.
8.2 System Information
In the navigation panel, click Basic Setting > System Info to display the screen as shown. Use this screen
to view general system information. You can check the firmware version number.