User manual

Chapter 9 VLAN
GS2210 Series User’s Guide
105
9.7.1 Configuring Protocol Based VLAN
Click the Protocol Based VLAN Setup link in the VLAN Configuration screen to display the configuration
screen as shown.
Note: Protocol-based VLAN applies to un-tagged packets and is applicable only when you
use IEEE 802.1Q tagged VLAN.
Figure 88 Advanced Application > VLAN > VLAN Configuration > Protocol Based VLAN Setup
Note: The following table describes the labels in this screen.
Table 38 Advanced Application > VLAN > VLAN Configuration > Protocol Based VLAN Setup
LABEL DESCRIPTION
Active Check this box to activate this protocol based VLAN.
Port Type a port to be included in this protocol based VLAN.
This port must belong to a static VLAN in order to participate in a protocol based VLAN. See
Chapter 9 on page 93 for more details on setting up VLANs.
Name Enter up to 32 alpha numeric characters to identify this protocol based VLAN.
Ethernet-type Use the drop down list box to select a predefined protocol to be included in this protocol based
VLAN or select Others and type the protocol number in hexadecimal notation. For example the IP
protocol in hexadecimal notation is 0800, and Novell IPX protocol is 8137.
Note: Protocols in the hexadecimal number range of 0x0000 to 0x05ff are not allowed
to be used for protocol based VLANs.
VID Enter the ID of a VLAN to which the port belongs. This must be an existing VLAN which you defined
in the Advanced Applications > VLAN screens.
Priority Select the priority level that the Switch will assign to frames belonging to this VLAN.
Add Click Add to save your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Index This is the index number identifying this protocol based VLAN. Click on any of these numbers to
edit an existing protocol based VLAN.
Active This field shows whether the protocol based VLAN is active or not.