User manual

Chapter 13 Spanning Tree Protocol
GS2210 Series User’s Guide
125
The following table describes the labels in this screen.
13.4 Configure Rapid Spanning Tree Protocol
Use this screen to configure RSTP settings, see Section 13.1 on page 121 for more information on RSTP.
Click RSTP in the Advanced Application > Spanning Tree Protocol screen.
Figure 103 Advanced Application > Spanning Tree Protocol > RSTP
Table 47 Advanced Application > Spanning Tree Protocol > Configuration
LABEL DESCRIPTION
Spanning Tree
Mode
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or Multiple Spanning Tree. See
Section 13.1 on page 121 for background information on STP.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.