User manual

Chapter 24 Multicast
GS2210 Series User’s Guide
198
24.4 IPv6 Multicast Status
Click Advanced Application > Multicast > IPv6 Multicast to display the screen as shown. This screen
shows the IPv6 multicast group information. See Section 24.1 on page 188 for more information on
multicasting.
Figure 146 Advanced Application > Multicast > IPv6 Multicast
The following table describes the fields in the above screen.
24.4.1 MLD Snooping-proxy
Click the MLD Snooping-proxy link in the Advanced Application > Multicast > IPv6 Multicast screen to
display the screen as shown. See Section 24.1 on page 188 for more information on multicasting.
Add Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Clear Click Clear to reset the fields to the factory defaults.
Profile Name This field displays the descriptive name of the profile.
Start Address This field displays the start of the multicast address range.
End Address This field displays the end of the multicast address range.
Delete Profile Select a profile’s check box to select a specific profile. Otherwise, select the check box in the
table heading row to select all profiles.
Delete Rule Select the check box(es) of the rule(s) that you want to remove from a profile.
Delete To delete the profile(s) and all the accompanying rules, select the profile(s) that you want to
remove in the Delete Profile column, then click the Delete button.
To delete a rule(s) from a profile, select the rule(s) that you want to remove in the Delete Rule
column, then click the Delete button.
Cancel Click Cancel to clear the Delete Profile/Delete Rule check boxes.
Table 81 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering Profile
LABEL DESCRIPTION
Table 82 Advanced Application > Multicast > IPv6 Multicast
LABEL DESCRIPTION
Index This is the index number of the entry.
VID This field displays the multicast VLAN ID.
Port This field displays the port number that belongs to the multicast group.
Multicast Group This field displays IP multicast group addresses.
Group Timeout This field displays the time (in seconds) that elapses before the Switch removes a MLD group
membership entry if it does not receive report messages from the port.