User manual

Chapter 24 Multicast
GS2210 Series User’s Guide
199
Figure 147 Advanced Application > Multicast > IPv6Multicast > MLD Snooping-proxy
The following table describes the fields in the above screen.
24.4.2 MLD Snooping-proxy VLAN
Click the VLAN link in the Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
screen to display the screen as shown. See Section 24.1 on page 188 for more information on
multicasting.
Figure 148 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > VLAN
Table 83 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
LABEL DESCRIPTION
MLD Snooping-proxy Use these settings to configure MLD snooping-proxy.
Active Select Active to enable MLD snooping-proxy on the Switch to minimize MLD control
messages and allow better network performance.
802.1p Priority Select a priority level (0-7) to which the Switch changes the priority in outgoing MLD
messages.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.