User manual

Chapter 28 VLAN Mapping
GS2210 Series User’s Guide
262
28.3 Configuring VLAN Mapping
Click the VLAN Mapping Configure link in the VLAN Mapping screen to display the screen as
shown. Use this screen to enable and edit the VLAN mapping rule(s).
Figure 193 VLAN Mapping Configure
The following table describes the labels in this screen.
Table 119 VLAN Mapping Configure
LABEL DESCRIPTION
Active Check this box to activate this rule.
Name Enter a descriptive name (up to 32 printable ASCII characters) for
identification purposes.
Port Type a port to be included in this rule.
VID Enter a VLAN ID from 1 to 4094. This is the VLAN tag carried in the packets
and will be translated into the VID you specified in the Translated VID field.
Translated VID Enter a VLAN ID (from 1 to 4094) into which the customer VID carried in the
packets will be translated.
Priority Select a priority level (from 0 to 7). This is the priority level that replaces the
customer priority level in the tagged packets or adds to the untagged
packets.
Add Click Add to insert the entry in the summary table below and save your
changes to the Switch’s run-time memory. The Switch loses these changes if
it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Index This is the number of the VLAN mapping entry in the table.
Active This shows whether this entry is activated or not.
Name This is the descriptive name for this rule.
Port This is the port number to which this rule is applied.