User manual

Chapter 34 Link Layer Discovery Protocol (LLDP)
GS2210 Series User’s Guide
304
The following table describes the labels in this screen.
34.6.2 LLDP Configuration Org-specific TLV Setting
Use this screen to configure organization-specific TLV settings. Click Advanced Application > LLDP > LLDP
Configuration (Click Here) > Org-specific TLV Setting to display the screen as shown next.
Figure 221 Advanced Application > LLDP > LLDP Configuration> Org-specific TLV Setting
Table 145 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL DESCRIPTION
Port This displays the Switch’s port number.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Management
Address
Select the check box(es) to enable or disable the sending of Management Address TLVs on
the port(s).
Port Description Select the check box(es) to enable or disable the sending of Port Description TLVs on the
port(s).
System Capabilities Select the check box(es) to enable or to disable the sending of System Capabilities TLVs on
the port(s).
System Description Select the check box(es) to enable or to disable the sending of System Description TLVs on
the port(s).
System Name Select the check box(es) to enable or to disable the sending of System Name TLVs on the
port(s).
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.