User manual

Chapter 35 Anti-Arpscan
GS2210 Series User’s Guide
313
Figure 226 Advanced Application > Anti-Arpscan > Host Status
The following table describes the labels in this screen.
35.4 Anti-Arpscan Trust Host
Use this screen to create or remove trusted hosts identified by IP address and subnet mask. Anti-arpscan
is not performed on trusted hosts. To open this screen, click Advanced Application > Anti-Arpscan > Trust
Host.
Figure 227 Advanced Application > Anti-Arpscan > Trust Host
Table 151 Advanced Application > Anti-Arpscan > Host Status
LABEL DESCRIPTION
Clear Filtered host: A filtered host is a blocked IP address.
Port List Type a port number or a series of port numbers separated by commas and spaces, and then
click Clear to unblock all hosts connected to these ports.
Filtered host: This table lists information on blocked hosts.
Index This displays the index number of an IP address (a host) that has been blocked.
Host IP This displays the IP address of the blocked host.
MAC This displays the MAC address of the blocked host.
VLAN This displays the VLAN ID that shows which VLAN the blocked host is in.
Port This displays the port number to which the blocked host is connected.
State This shows Err-Disable if the ARP-request rate from this host is over the threshold. Forwarding
hosts are not displayed.