User manual

Chapter 3 Hardware Panels

GS2210 Series User’s Guide

Figure 24 Rear Panel: GS2210-48

Figure 25 Rear Panel: GS2210-48HP

3.2.1 Console Port

For local management, you can use a computer with terminal emulation software configured to the

following parameters:

• VT100

• Terminal emulation

• 9600 bps

• No parity, 8 data bits, 1 stop bit

• No flow control

Connect the male 9-pin end of the console cable to the console port of the Switch. Connect the

female end to a serial port (COM1, COM2 or other COM port) of your computer.

3.2.2 Power Connector

Note: Make sure you are using the correct power source as shown on the panel.

To connect power to the Switch, insert the female end of the power cord to the AC power receptacle

on the rear panel. Connect the other end of the supplied power cord to a power outlet. Make sure that

no objects obstruct the airflow of the fans (located on the side of the unit).

See Chapter 55 on page 421 for information on the Switch’s power supply requirements.

3.3 LEDs

After you connect the power to the Switch, view the LEDs to ensure proper functioning of the Switch

and as an aid in troubleshooting.

Table 4 LED Descriptions

LED COLOR STATUS DESCRIPTION

PoE

(GS2210 48HP

only)

Green On Each Ethernet port’s LED is changed to act as a PoE LED by using the LED

MODE button on the front panel.

Off Each Ethernet port’s LED is changed back to act as a LNK/ACT LED by

releasing the LED MODE button on the front panel.

PWR Green On The system is turned on.

Off The system is off or has failed.