User manual

Chapter 41 DHCP
GS2210 Series User’s Guide
345
Figure 251 DHCP Relay Configuration Example
41.4.6 Configuring DHCPv4 VLAN Settings
Use this screen to configure your DHCP settings based on the VLAN domain of the DHCP clients. Click IP
Application > DHCP > DHCPv4 in the navigation panel, then click the VLAN link In the DHCP Status screen
that displays.
Note: You must set up a management IP address for each VLAN that you want to configure
DHCP settings for on the Switch. See Section 5.1.3 on page 48 for information on how to
do this.
Figure 252 IP Application > DHCP > DHCPv4 > VLAN
The following table describes the labels in this screen.
EXAMPLE
Table 174 IP Application > DHCP > DHCPv4 > VLAN
LABEL DESCRIPTION
VID Enter the ID number of the VLAN to which these DHCP settings apply.
Remote DHCP
Server 1 .. 3
Enter the IP address of a DHCP server in dotted decimal notation.
Option 82 Profile Select a pre-defined DHCP option 82 profile that the Switch applies to all ports in this VLAN. The
Switch adds the Circuit ID sub-option and/or Remote ID sub-option specified in the profile to
DHCP requests that it relays to a DHCP server.