User manual

Chapter 43 Maintenance
GS2210 Series User’s Guide
357
Note: If a customized default file was not saved, clicking Custom Default loads the Config 2
file on the Switch.
Note: If a Config 2 file was not saved, nor was a customized default file, clicking Custom
Default loads the Zyxel factory default configuration settings on the Switch.
Alternatively, click Save on the top right-hand corner in any screen to save the configuration changes
to the current configuration.
Note: Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.
43.2.3 Reboot System
Reboot System allows you to restart the Switch without physically turning the power off. It also allows you
to load configuration one (Config 1), configuration two (Config 2), a Custom Default or the factory
deault configuration when you reboot. Follow the steps below to reboot the Switch.
1 In the Maintenance screen, click a configuration button next to Reboot System to reboot and load that
configuration file. The following screen displays.
Figure 261 Reboot System: Confirmation
2 Click OK again and then wait for the Switch to restart. This takes up to two minutes. This does not affect
the Switch’s configuration.
Click Config 1 and follow steps 1 to 2 to reboot and load configuration one on the Switch.
Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the Switch.
Click Factory Default and follow steps 1 to 2 to reboot and load Zyxel factory default configuration
settings on the Switch.
Click Custom Default and follow steps 1 to 2 to reboot and load a customized default file on the Switch.
43.3 Firmware Upgrade
Use the following screen to upgrade your Switch to the latest firmware. The Switch supports dual
firmware images, Firmware 1 and Firmware 2. Use this screen to specify which image is updated when
firmware is uploaded using the web configurator and to specify which image is loaded when the Switch
starts up.