User manual
Chapter 44 Access Control
GS2210 Series User’s Guide
380
errdisable zyErrdisableDetect 1.3.6.1.4.1.890.1.15.3.24.4.1 This trap is sent when an error is detected
on a port, such as a loop occurs or the rate
limit for specific control packets is
exceeded.
zyErrdisableRecovery 1.3.6.1.4.1.890.1.15.3.24.4.2 This trap is sent when the Switch ceases the
action taken on a port, such as shutting
down the port or discarding packets on the
port, after the specified recovery interval.
poe
(For PoE models
only)
zyPoePowerPortOverload 1.3.6.1.4.1.890.1.15.3.59.4.1 This trap is sent when the port is turned off to
supply power due to overloading.
zyPoePowerPortShortCircuit 1.3.6.1.4.1.890.1.15.3.59.4.2 This trap is sent when the port is turned off to
supply power due to short circuit.
zyPoePowerPortOverSystem
Budget
1.3.6.1.4.1.890.1.15.3.59.4.3 This trap is sent when the port is turned off to
supply power because the requested
power exceeds the total PoE power
budget on the Switch.
zyPoePowerPortOverloadRe
covered
1.3.6.1.4.1.890.1.15.3.59.4.5 This trap is sent when the port is turned on to
recover from an overloaded state.
zyPoePowerPortShortCircuitR
ecovered
1.3.6.1.4.1.890.1.15.3.59.4.6 This trap is sent when the port is turned on to
recover from a short circuit.
zyPoePowerPortOverSystem
BudgetRecovered
1.3.6.1.4.1.890.1.15.3.59.4.7 This trap is sent when the port is turned on to
recover from an over system budget.
loginrecord zyAccessControlLoginRecor
d
1.3.6.1.4.1.890.1.15.3.9.4.1 This trap is sent when users log in.
zyAccessControlLogoutRec
ord
1.3.6.1.4.1.890.1.15.3.9.4.2 This trap is sent when users log out.
zyAccessControlLoginFail 1.3.6.1.4.1.890.1.15.3.9.4.3 This trap is sent when users fail in login.
Table 193 SNMP System Traps (continued)
OPTION OBJECT LABEL OBJECT ID DESCRIPTION
Table 194 SNMP Interface Traps
OPTION OBJECT LABEL OBJECT ID DESCRIPTION
linkup linkUp 1.3.6.1.6.3.1.1.5.4 This trap is sent when the Ethernet link
is up.
linkdown linkDown 1.3.6.1.6.3.1.1.5.3 This trap is sent when the Ethernet link
is down.
lldp lldpRemTablesChange 1.0.8802.1.1.2.0.0.1 The trap is sent when entries in the
remote database have any updates.
Link Layer Discovery Protocol (LLDP),
defined as IEEE 802.1ab, enables LAN
devices that support LLDP to
exchange their configured settings.
This helps eliminate configuration
mismatch issues.