User manual

Chapter 47 Syslog Setup
GS2210 Series User’s Guide
396
Figure 292 Management > Syslog Setup
The following table describes the labels in this screen.
Table 200 Management > Syslog Setup
LABEL DESCRIPTION
Syslog Select Active to turn on syslog (system logging) and then configure the syslog setting
Logging Type This column displays the names of the categories of logs that the device can generate.
Active Select this option to set the device to generate logs for the corresponding category.
Facility The log facility allows you to send logs to different files in the syslog server. Refer to the
documentation of your syslog program for more details.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Syslog Server Setup
Active Select this check box to have the device send logs to this syslog server. Clear the check box
if you want to create a syslog server entry but not have the device send logs to it (you can
edit the entry later).
Server Address Enter the IPv4 or IPv6 address of the syslog server.
UDP Port The default syslog server port is 514. If your syslog server uses a different port, configure the
one it uses here.