User manual

Chapter 5 Initial Setup Example
GS2210 Series User’s Guide
49
Figure 34 Initial Setup Example: Management IP Address
1 Connect your computer to any Ethernet port on the Switch. Make sure your computer is in the same
subnet as the Switch.
2 Open your web browser and enter 192.168.1.1 (the default IP address) in the address bar to access the
web configurator. See Section 4.2 on page 36 for more information.
3 Click Basic Setting > IP Setup in the navigation
panel.
4 Configure the related fields in the IP Setup screen.
5 For the VLAN2 network, enter 192.168.2.1 as the IP
address and 255.255.255.0 as the subnet mask.
6 In the VID field, enter the ID of the VLAN group to
which you want this management IP address to
belong. This is the same as the VLAN ID you
configure in the Static VLAN screen.
7 Click Add to save your changes back to the run-
time memory. Settings in the run-time memory are
lost when the Switch’s power is turned off.