User manual

Chapter 6 Tutorials
GS2210 Series User’s Guide
58
• Enter the filename of an auto configuration file. The Switch will load this auto configuration file
when rebooting with DHCP option 60 disabled.
• If you want to load the auto configuration file with DHCP option 60 enabled and a Vendor Class
Identifier assigned when you reboot the Switch, follow the instruction below. Otherwise, skip this
step.
Enter the filename of the an auto configuration file. Set up a Vendor Class Identifier. To have the
Switch load this auto configuration file, two conditions listed above must be met. Please refer to
the following steps to see how to set up a Vendor Class Identifier on the Switch.
Setting up a TFTP Server
1 Select a directory on the TFTP server.
2 Put the configuration files in that directory.
Setting up the Switch
1 Open the web configurator. Go to the Management > Maintenance screen, and click the Click Here
button next to the Auto Configuration field.
Figure 48 Tutorial: Auto Configuration Screen
2 Select the checkbox in the Active field to enable auto configuration, and click Apply to save your
changes. See Section 43.6 on page 360 for more information about auto configuration.