User manual

Chapter 6 Tutorials
GS2210 Series User’s Guide
60
6 Click the same button next to Reboot System field to reboot the Switch, and load the auto configuration
setting as configured before. For example, if you save the auto configuration setting to Config 1, you
need to click the Config 1 button next to the Reboot System field. See Section 43.2.3 on page 357 for
more information.
Figure 51 Tutorial: Save Configuration & Reboot System
7 Go to the Management > System Log screen to see if auto configuration was performed successfully.
Figure 52 Tutorial: Log
8 Check the screens to see if it’s the configuration file you want to load. If it’s not, go through the steps
above to check your configurations. If it is, click Save at the top right corner of the web configurator to
save the configuration permanently.
Figure 53 Tutorial: Save