User manual

Chapter 7 Status and ZON

GS2210 Series User’s Guide

Desc. This shows the port description of the Switch.

PoE Draw This shows the consumption that the neighboring device connected to this port draws

from the Switch. This allows you to plan and use within the power budget of the Switch.

Remote

Port This show the number of the neighbor device’s port which is connected to the Switch.

Desc. This shows the description of the neighbor device’s port which is connected to the

Switch.

Model This shows the model name of the neighbor device. This field will show “-” for non-Zyxel

devices.

System Name This shows the system name of the neighbor device.

Location This shows the geographic location of the neighbor device.

Firmware This shows the firmware version of the neighbor device. This field will show “-” for non-Zyxel

devices.

IP This shows the IP address of the neighbor device. The IP address is a hyper link that you

can click to log into and manage the neighbor device through its web configurator. This

field will show “-” for non-Zyxel devices.

MAC This shows the MAC address of the neighbor device. This field will show “-” for non-Zyxel

devices.

PWR Cycle Click the Cycle button to turn OFF the power of the neighbor device and turn it back ON

again. A count down button (from 5 to 0) starts.

Note:

• The Switch must support power sourcing (PSE) or the network device is a powered

device (PD).

• If multiple neighbor devices use the same port, the Cycle button is displayed only on

the first device, others will show “-” instead.

Reset to Default Click the Reset button to reset the neighbor device to its factory default settings. A

warning message “Are you sure you want to load factory default?” appears prompting

you to confirm the action. After confirming the action a count down button (from 5 to 0)

starts.

Note:

• The Switch must support power sourcing (PSE) or the network device is a powered

device (PD).

• If multiple neighbor devices use the same port, the Reset button is not available and

will show “-” instead.

• You can only reset Zyxel products.

Table 10 Status > Neighbor

LABEL DESCRIPTION