User's Manual

Chapter 12 Interfaces
ISG50 User’s Guide
253
Figure 178 Configuration > Network > Interface > Cellular
The following table describes the labels in this screen.
12.5.1 Cellular Add/Edit Screen
To change your 3G settings, click Configuration > Network > Interface > Cellular > Add (or
Edit). In the pop-up window that displays, select the slot that you want to configure. The following
screen displays.
Table 70 Configuration > Network > Interface > Cellular
LABEL DESCRIPTION
Add Click this to create a new cellular interface.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The ISG50 confirms you want to remove it
before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Connect To connect an interface, select it and click Connect. You might use this in testing the
interface or to manually establish the connection.
Disconnect To disconnect an interface, select it and click Disconnect. You might use this in testing the
interface.
Object
References
Select an entry and click Object References to open a screen that shows which settings
use the entry. See Section 12.3.2 on page 246 for an example.
# This field is a sequential value, and it is not associated with any interface.
Status The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
The connect icon is lit when the interface is connected and dimmed when it is
disconnected.
Name This field displays the name of the interface.
Extension Slot This field displays where the entry’s cellular card is located.
Connected
Device
This field displays the name of the cellular card.
ISP Settings This field displays the profile of ISP settings that this cellular interface is set to use.
Apply Click Apply to save your changes back to the ISG50.
Reset Click Reset to return the screen to its last-saved settings.