User's Manual

Chapter 16 Zones
ISG50 User’s Guide
315
The following table describes the labels in this screen.
16.3 Zone Edit
The Zone Edit screen allows you to add or edit a zone. To access this screen, go to the Zone
screen (see Section 16.2 on page 314), and click the Add icon or an Edit icon.
Figure 209 Network > Zone > Add
Table 97 Configuration > Network > Zone
LABEL DESCRIPTION
User
Configuration /
System Default
The ISG50 comes with pre-configured System Default zones that you cannot
delete. You can create your own User Configuration zones
Add Click this to create a new, user-configured zone.
Edit Double-click an entry or select it and click Edit to open a screen where you can
modify the entry’s settings.
Remove To remove a user-configured trunk, select it and click Remove. The ISG50
confirms you want to remove it before doing so.
Object
References
Select an entry and click Object References to open a screen that shows which
settings use the entry. See Section 12.3.2 on page 246 for an example.
# This field is a sequential value, and it is not associated with any interface.
Name This field displays the name of the zone.
Block Intra-zone This field indicates whether or not the ISG50 blocks network traffic between
members in the zone.
Member This field displays the names of the interfaces that belong to each zone.