User's Manual

Chapter 23 Firewall
ISG50 User’s Guide
366
The following table describes the labels in this screen.
Table 120 Configuration > Firewall > Session Limit > Edit
LABEL DESCRIPTION
Create new
Object
Use to configure any new settings objects that you need to use in this screen.
Enable Rule Select this check box to turn on this session limit rule.
Description Enter information to help you identify this rule. Use up to 64 printable ASCII
characters. Spaces are allowed.
User Select a user name or user group to which to apply the rule. The rule is activated
only when the specified user logs into the system and the rule will be disabled
when the user logs out.
Otherwise, select any and there is no need for user logging.
Note: If you specified an IP address (or address group) instead of any in the field
below, the user’s IP address should be within the IP address range.
Address Select a source address or address group for whom this rule applies. Select any
if the policy is effective for every source address.
Session Limit per
Host
Use this field to set a limit to the number of concurrent NAT/firewall sessions this
rule’s users or addresses can have.
For this rule’s users and addresses, this setting overrides the Default Session
per Host setting in the general Firewall Session Limit screen.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.