User's Manual

Chapter 34 Call Services
ISG50 User’s Guide
535
34.3.1 Configuring the Call Park Screen
Use this screen to configure call parking on the ISG50. Click Configuration > PBX > Call Service
> Call Park to open the screen.
Figure 355 Configuration > PBX > Call Service > Call Park
The following table describes the labels in this screen.
5. The ISG50 parks the call and
informs caller B of the number to
call to reconnect to the call. This is
called the parking slot number.
6. Caller B walks to another
extension and reconnects to the
call with A by dialing the parking
slot number.
Conversation between caller A and B continues
Table 189 Call Parking Progression
CALLER A ISG50 CALLER B
Table 190 Configuration > PBX > Call Service > Call Park
LABEL DESCRIPTION
Representative
Parking Extension
Enter the telephone number users should dial to park a telephone call. You can use 3-8
digits.
Number of Parking
Slots
Enter the total number of call parking slot extensions to make available. This also
establishes the range of numbers that users will have to dial to retrieve a parked call. You
can use 1-99 positions.
Parking Expired
Time
Enter the maximum number of seconds that a call can be parked. After a parked call
exceeds this amount of time, it will ring back to the extension that parked the call. The
range you can use is 60-300 seconds.
Apply Click this to save your changes and to apply them to the ISG50.
Reset Click this to set every field in this screen to its last-saved value.