User Manual

Chapter 17 Bandwidth Management
LTE3301 Series User’s Guide
114
The sum of the bandwidth allotments that apply to the LAN interface (WAN to LAN, WAN to WLAN) must
be less than or equal to the downstream bandwidth that you configure in the Ba ndwid th Ma na g e m e nt
> G e ne ra l screen
Section 17.5 on page 114.
17.4 G e ne ra l Sc re e n
Use this screen to have the LTE3301 apply bandwidth management.
Click Ma na g e m e nt > Ba ndwidth MG MT to open the bandwidth management G e ne ra l screen.
Fig ure 75 Management > Bandwidth Management > General
The following table describes the labels in this screen.
17.5 Adva nc e d Sc re e n
Use this screen to configure bandwidth management rules for the pre-defined services or applications.
Table 51 Management > Bandwidth Management > General
LABEL DESC RIPTIO N
Enable Bandwidth
Management
This field allows you to have LTE3301 apply bandwidth management.
Enable bandwidth management to give traffic that matches a bandwidth rule priority over
traffic that does not match a bandwidth rule.
Enabling bandwidth management also allows you to control the maximum or minimum
amounts of bandwidth that can be used by traffic that matches a bandwidth rule.
Bandwidth of
Upstream
Specify the total amount of bandwidth that you want to dedicate to uplink traffic. The
recommendation is to set this to match the actual upstream data rate.
This is traffic from LAN/WLAN to WAN.
Bandwidth of
Downstream
Specify the total amount of bandwidth that you want to dedicate to downlink traffic. The
recommendation is to set this to match the actual downstream data rate.
This is traffic from WAN to LAN/WLAN.
Flexible Bandwidth
Management
Select Ena ble to use up to 100% of the configured bandwidth. If you select Disa b le , you can
only use up to 33% of the configured bandwidth.
Apply Click App ly to save your customized settings.
Cancel Click C a nc e l to begin configuring this screen afresh.