User Manual

Chapter 7 Wireless LAN
LTE3301 Series User’s Guide
70
The following table describes the labels in this screen.
7.4 Mo re AP Sc re e n
This screen allows you to enable and configure multiple wireless networks and guest wireless network
settings on the LTE3301.
You can configure up to four SSIDs to enable multiple BSSs (Basic Service Sets) on the LTE3301. This allows
you to use one access point to provide several BSSs simultaneously. You can then assign varying security
types to different SSIDs. Wireless clients can use different SSIDs to associate with the same access point.
Click Ne two rk > Wire le ss LAN > Mo re AP. The following screen displays.
Fig ure 39 Network > Wireless LAN > More AP
Table 22 Network > Wireless LAN > General: WPA/WPA2
LABEL DESC RIPTIO N
Security Mode Select WPA or WPA 2 to enable data encryption.
WPA Compatible This check box is available only when you select WPA2- PSK or WPA2 in the Se c urity Mo de
field.
Select the check box to have both WPA2 and WPA wireless clients be able to
communicate with the LTE3301 even when the LTE3301 is using WPA2-PSK or WPA2.
Group Key Update
Timer
The Gro up Ke y Upda te Tim e r is the rate at which the AP (if using WPA- PSK/ WPA2- PSK key
management) or RADIUS server (if using WPA/ WPA2 key management) sends a new group
key out to all clients. The re-keying process is the WPA/WPA2 equivalent of automatically
changing the WEP key for an AP and all stations in a WLAN on a periodic basis. Setting of
the Gro up Ke y Upda te Tim e r is also supported in WPA - PSK/ WPA2- PSK mode.
Authentication Server
IP Address Enter the IP address of the external authentication server in dotted decimal notation.
Port Number Enter the port number of the external authentication server.
You need not change this value unless your network administrator instructs you to do so
with additional information.
Shared Secret Enter a password (up to 127 alphanumeric characters) as the key to be shared between
the external authentication server and the LTE3301.
The key must be the same on the external authentication server and your LTE3301. The key
is not sent over the network.
Apply Click Ap ply to save your changes back to the LTE3301.
Cancel Click Ca nc e l to reload the previous configuration for this screen.