User Manual

Chapter 7 Wireless LAN
LTE3301 Series User’s Guide
79
Fig ure 47 Network > Wireless LAN > WDS
The following table describes the labels in this screen.
Table 31 Network > Wireless LAN > WDS
LABEL DESC RIPTIO N
WDS Setup
Basic Setting Select Disa b le to turn off the WDS function on the LTE3301.
Select AP+Bridg e to have the LTE3301 function as a bridge and access point simultaneously.
Select Brid g e O nly to have the LTE3301 act as a wireless bridge only.
Local MAC Address This shows the MAC address of the LTE3301.
Phy Mode Select the physical mode supported by the LTE3301.
You must also set the peer device to use the same physical mode.
Remote MAC
Address
Type the MAC address of the peer device in a valid MAC address format, that is, six
hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Security
Encryp Type Select the type of security you want to use (TKIP or AES) to secure traffic on your WDS.
Otherwise, select No Se c urity.
Select TKIP to enable Temporal Key Integrity Protocol (TKIP) security on your WDS. This option
is compatible with other ZyXEL access points that support WDS security. Use this if the other
access points on your network support WDS security but do not have an AES option.
AES provides superior security to TKIP. Use AES if the other access points on your network
support it for the WDS.
Encryp Key Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including spaces and
symbols).
You must also set the peer device to use the same pre-shared key.
Apply Click Apply to save your changes back to the LTE3301.
Reset Click Re se t to reload the previous configuration for this screen.