User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 8 Routing
LTE Series User’s Guide
101
8.3 DNS Route
Use this screen to view and configure DNS routes on the Zyxel Device. A DNS route entry defines a policy
for the Zyxel Device to forward a particular DNS query to a specific WAN interface. Click Network Setting
> Routing > DNS Route to open the DNS Route screen.
Figure 75 Network Setting > Routing > DNS Route
The following table describes the labels in this screen.
8.3.1 Add/Edit DNS Route
Click Add New DNS Route in the DNS Route screen, use this screen to configure the required information
for a DNS route.
Table 28 Network Setting > Routing > DNS Route
LABEL DESCRIPTION
Add New DNS
Route
Click this to create a new entry.
# This is the number of an individual DNS route.
Status This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
Domain Name This is the domain name to which the DNS route applies.
WAN Interface This is the WAN interface through which the matched DNS request is routed.
Subnet Mask This parameter specifies the IP network subnet mask.
Modify Click the Edit icon to configure a DNS route on the Zyxel Device.
Click the Delete icon to remove a DNS route from the Zyxel Device.