User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 10 Dynamic DNS Setup
LTE Series User’s Guide
118
Figure 89 DNS Entry: Add/Edit
The following table describes the labels in this screen.
10.3 Dynamic DNS
Dynamic DNS can update your current dynamic IP address mapping to a hostname. Configure a DDNS
service provider on your Zyxel Device. Click Network Setting > DNS > Dynamic DNS. The screen appears
as shown.
Table 40 DNS Entry: Add/Edit
LABEL DESCRIPTION
Host Name Enter the host name of the DNS entry.
IPv4 Address Enter the IPv4 address of the DNS entry.
Cancel Click Cancel to exit this screen without saving.
OK Click OK to save your changes.