User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 12 Firewall
LTE Series User’s Guide
132
Figure 98 Security > Firewall > Access Control > Add New ACL Rule
The following table describes the labels in this screen.
Table 48 Security > Firewall > Access Control > Add New ACL Rule
LABEL DESCRIPTION
Filter Name Type a unique name for your filter rule.
Order Assign the order of your rules as rules are applied in turn.
Select Source IP
Address
If you want the source to come from a particular (single) IP, select Specific IP Address. If
not, select from a detected device.
Source IP Address If you selected Specific IP Address in the previous item, enter the source device’s IP
address here. Otherwise this field will be hidden if you select the detected device.
Select Destination
Device
If you want your rule to apply to packets with a particular (single) IP, select Specific IP
Address. If not, select a detected device.
Destination IP Address If you selected Specific IP Address in the previous item, enter the destination device’s IP
address here. Otherwise this field will be hidden if you select the detected device.