User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
LTE Series User’s Guide
151
CHAPTER 16
Traffic Status
16.1 Traffic Status Overview
Use the Traffic Status screens to look at the network traffic status and statistics of the WAN/LAN
interfaces.
16.1.1 What You Can Do in this Chapter
• Use the WAN screen to view the WAN traffic statistics (Section 16.2 on page 151).
• Use the LAN screen to view the LAN traffic statistics (Section 16.3 on page 152).
16.2 WAN Status
Click System Monitor > Traffic Status to open the WAN screen. The figures in this screen show the number
of bytes received and sent through the Zyxel Device’s WAN interface. The table below shows packet
statistics for each WAN interface.
Figure 112 System Monitor > Traffic Status > WAN