User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 19 Cellular WAN Status
LTE Series User’s Guide
163
BSIC The Base Station Identity Code (BSIC), which is a code used in GSM to uniquely identify a base
station.
This parameter is for GPRS only. The value is ‘0’ (zero) if the Current Access Technology is not
GPRS. The value is ‘N/A’ if there is no network connection.
SINR This displays the Signal to Interference plus Noise Ratio (SINR) in dB. This is also a measure of signal
quality and used by the UE (User Equipment) to calculate the Channel Quality Indicator (CQI)
that it reports to the network. A negative value means more noise than signal.
CQI This displays the Channel Quality Indicator (CQI). It is an indicator carrying the information on
how good/bad the communication channel quality is.
MCS MCS stands for modulation coding scheme. The base station selects MCS based on current
radio conditions. The higher the MCS the more bits can be transmitted per time unit.
RI This displays the Rank Indication, one of the control information that a UE will report to eNodeB
(Evolved Node-B) on either PUCCH (Physical Uplink Control Channel) or PUSCH (Physical Uplink
Shared Channel) based on uplink scheduling.
PMI This displays the Precoding Matrix Indicator (PMI).
PMI is for transmission modes 4 (closed loop spatial multiplexing), 5 (multi-user MIMO), and 6
(closed loop spatial multiplexing using a single layer).
PMI determines how cellular data are encoded for the antennas to improve downlink rate.
Table 65 System Monitor > Cellular WAN Status (continued)
LABEL DESCRIPTION