User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
LTE Series User’s Guide
168
CHAPTER 22
Remote Management
22.1 Overview
Remote management controls through which interface(s), which web services (such as HTTP, HTTPS, FTP,
Telnet, SSH and Ping) can access the Zyxel Device.
Note: The Zyxel Device is managed using the Web Configurator.
22.2 MGMT Services
Note: The MGMT Services screen will be hidden if you enable the IP Passthrough function in
Network Setting > Broadband > Cellular IP Passthrough screen.
Use this screen to configure the interfaces through which services can access the Zyxel Device. Click
Maintenance > Remote Management to open the following screen.
Figure 121 Maintenance > Remote Management