User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 22 Remote Management
LTE Series User’s Guide
171
The following table describes the fields in this screen.
22.5 Add Trust Domain
Use this screen to add a public IP addresses or a complete domain name of a device which is allowed
to access the Zyxel Device. Click the Add Trust Domain button in the Maintenance > Remote
Management > Trust Domain screen to open the following screen.
Figure 124 Maintenance > Remote Management > Trust Domain > Add Trust Domain
The following table describes the fields in this screen.
22.6 Trust Domain for IP Passthrough
Use this screen to view a list of public IP addresses/complete domain names which are allowed to
access the Zyxel Device in IP Passthrough mode (bridge mode). IP Passthrough allows Internet traffic to
go to a LAN computer behind the Zyxel Device without going through NAT. Make sure to enable IP
Passthrough in Network Setting > Broadband > Cellular IP Passthrough. See Section 6.8 on page 73 for
details.
Click Maintenance > Remote Management > Trust Domain for IP Passthrough to open the following
screen.
Table 71 Maintenance > Remote Management > Trust Domain
LABEL DESCRIPTION
Add Trust
Domain
Click this to add a trusted host IP address.
IP Address This field shows a trusted host IP address.
Delete Click the Delete icon to remove the trusted host IP address.
Table 72 Maintenance > Remote Management > Trust Domain > Add Trust Domain
LABEL DESCRIPTION
IP Address Enter a public IPv4/IPv6 IP address which is allowed to access the service on the Zyxel Device
from the WAN.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to restore your previously saved settings.