User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 1 Introduction
LTE Series User’s Guide
17
1.5.1 LEDs (Lights)
1.5.2 Panel Ports & Buttons
The connection ports are located on the bottom/rear panels.
The following table describes the items on the bottom panel.
Table 2 LTE7461-M602 / LTE7480-S905 / LTE7485-S905 LED Descriptions
COLOR STATUS DESCRIPTION
Red Blinking The Zyxel Device is booting or self-testing.
On The Zyxel Device encountered an error.
Green Blinking The Zyxel Device is trying to connect to the Internet.
On The Zyxel Device is connected to the Internet.
Amber Blinking The Zyxel Device WiFi is on.
Table 3 LTE5388-S905 LED Descriptions
LED COLOR STATUS DESCRIPTION
Power Green On The Zyxel Device is receiving power and ready for use.
Blinking The Zyxel Device is booting.
Off The Zyxel Device is not receiving power.
Internet Green On There is an Internet connection.
Off There is no Internet connection.
LTE Signal Strength Green On The signal strength is excellent.
Orange On The signal strength is fair.
Red On The signal strength is poor.
Blinking A valid SIM card is inserted, but no signal is detected.
WiFi/WPS Green On The wireless network is activated.
Blinking The WPS process is in progress.
Off The WiFi/WPS is not activated.
LAN Green On The Zyxel Device recognizes an Ethernet cable through the
LAN port.
Table 4 Panel Ports and Buttons
LABELS DESCRIPTION
LAN For LTE5388-S905, connect an RJ45 cable to a computer to connect to the internal network In
using a LAN port.
WiFi Press the WLAN (WiFi) button for more than five seconds to enable the wireless function. To set
up a WiFi connection between the Zyxel Device and a wireless client, press the WPS button for
longer than five seconds for LTE5388-S905.
WPS After the wireless function is enabled, press the WLAN button for more than one second but
less than five seconds to quickly set up a secure wireless connection between the Zyxel
Device and a WPS-compatible client. To enable WPS, press the WPS button for less than five
seconds for LTE5388-S905.
RESET Press the button for more than five seconds to return the Zyxel Device to the factory defaults.