User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
LTE Series User’s Guide
179
CHAPTER 25
Log Setting
25.1 Log Setting Overview
Use this screen to configure where the Zyxel Device sends logs, and which type of logs the Zyxel Device
records.
25.2 Log Setting
You can configure where the Zyxel Device sends logs and which type of logs the Zyxel Device records in
the Logs Setting screen.
If you have a server that is running a syslog service, you can also save log files to it by enabling Syslog
Logging, and then entering the IP address of the server in the Syslog Server field. Select Remote to store
logs on the syslog server, or select Local File to store logs on the Zyxel Device. Select Local File and
Remote to store logs on both the Zyxel Device and the syslog server. To change your Zyxel Device’s log
settings, click Maintenance > Log Setting. The screen appears as shown.