User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
LTE Series User’s Guide
187
CHAPTER 28
Diagnostic
28.1 Diagnostic Overview
The Diagnostic screens display information to help you identify problems with the Zyxel Device.
28.2 Ping/TraceRoute/Nslookup Test
Use this screen to ping, traceroute, or nslookup for troubleshooting. Ping and traceroute are used to test
whether a particular host is reachable. After entering an IP address and clicking one of the buttons to
start a test, the results will be shown in the Ping/Traceroute Test area. Use nslookup to find the IP address
for a host name and vice versa. Click Maintenance > Diagnostic to open the Ping/TraceRoute/Nslookup
screen shown next.
Figure 136 Maintenance > Diagnostic > Ping/Trace Route/Nslookup
The following table describes the fields in this screen.
Table 81 Maintenance > Diagnostic
LABEL DESCRIPTION
Ping/
TraceRoute
Test
The result of tests is shown here in the info area.
TCP/IP