User's Guide

Chapter 1 Introduction
LTE Series User’s Guide
19
For LTE7461-M602 / LTE7480-S905 / LTE7485-S905:
Once WiFi is turned on, the LED blinks amber.
For LTE5388-S905:
Once WiFi is turned on, the LED turns green.
To activate WPS (WiFi must be already on):
You can also quickly set up a secure wireless connection between the Zyxel Device and a WPS-
compatible client by adding one device at a time.
• Press the WiFi or WiFi/WPS button for more than 1 second but less than 5 seconds and release it
(pressing more than 5 seconds will turn off WiFi). Press the WPS button on another WPS-enabled
device within range of the Zyxel Device.
For LTE7461-M602 / LTE7480-S905 / LTE7485-S905:
Once a wireless connection is ready, the LED blinks amber.
For LTE5388-S905:
Once a wireless connection is ready, the WPS LED blinks green.
To turn off the wireless network:
• Press the WiFi or WiFi/WPS button for more than 5 seconds.
For LTE7461-M602 / LTE7480-S905 / LTE7485-S905:
The amber LED turns off when the wireless network is off.
For LTE5388-S905:
The WLAN LED turns off when the wireless network is off.
1.5.4 The RESET Button
If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button of the Zyxel Device as shown in the following figure to reload the factory-default configuration
file. This means that you will lose all configurations that you had previously saved. The password will be
reset to the default (see the Zyxel Device label) and the IP address will be reset to 192.168.1.1.
Figure 9 Reset Button (LTE7461-M602 / LTE7480-S905 / LTE7485-S905)