User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 2 The Web Configurator
LTE Series User’s Guide
25
2.2.1.2 Navigation Panel
Use the menu items on the navigation panel to open screens to configure Zyxel Device features. The
following tables describe each menu item.
Table 6 Navigation Panel Summary
LINK TAB FUNCTION
Home Use this screen to configure basic Internet access and wireless settings.
This screen also shows the network status of the Zyxel Device and
computers/devices connected to it.
Network Setting
Broadband Broadband Use this screen to view and configure ISP parameters, WAN IP address
assignment, and other advanced properties.
Cellular WAN Use this screen to configure an LTE WAN connection.
Cellular APN Use this screen to configure the Access Point Name (APN) provided by
your service provider.
Cellular SIM
Use this screen to enter a PIN for your SIM card to prevent others from
using it.
Cellular Band Use this screen to configure the LTE frequency bands that can be used
for Internet access as provided by your service provider.
Cellular PLMN Use this screen to view available PLMNs and select your preferred
network.
Cellular IP
Passthrough
Use this screen to enable IP Passthrough mode (bridge mode).
Cellular Lock Use this screen to enable or disable PCI Lock.
Home
Networking
LAN Setup Use this screen to configure LAN TCP/IP settings, and other advanced
properties.
Static DHCP Use this screen to assign specific IP addresses to individual MAC
addresses.
UPnP Use this screen to turn UPnP and UPnP NAT-T on or off.
Routing Static Route Use this screen to view and set up static routes on the Zyxel Device.
DNS Route Use this screen to forward DNS queries for certain domain names through
a specific WAN interface to its DNS server(s).
Policy Route
Use this screen to configure policy routing on the Zyxel Device.
RIP Use this screen to configure Routing Information Protocol to exchange
routing information with other routers.
NAT Port Forwarding Use this screen to make your local servers visible to the outside world.
Port Triggering Use this screen to change your Zyxel Device’s port triggering settings.
DMZ Use this screen to configure a default server which receives packets from
ports that are not specified in the Port Forwarding screen.
ALG Use this screen to enable or disable SIP ALG.
DNS DNS Entry Use this screen to view and configure DNS routes.
Dynamic DNS Use this screen to allow a static hostname alias for a dynamic IP address.
Security
Firewall General Use this screen to configure the security level of your firewall.
Protocol Use this screen to add Internet services and configure firewall rules.
Access Control Use this screen to enable specific traffic directions for network services.
DoS Use this screen to activate protection against Denial of Service (DoS)
attacks.