User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 4 Tutorials
LTE Series User’s Guide
38
Figure 25 Example WPS Process: PIN Method
4.3 Connect to the Zyxel Device’s WiFi Network
In this example, you’ve configured the Zyxel Device’s WiFi Network to the following settings.
Wireless Client
LTE
Enter WPS PIN
WPS
from other device:
Authentication by PIN
SECURITY INFO
COMMUNICATION
WITHIN 2 MINUTES
WPS
START
LTE
LTE
LTE
LTE
SSID SSID_Example