User's Guide
Table Of Contents
- LTE Series
- User’s Guide
- Introduction
- The Web Configurator
- Quick Start
- Tutorials
- 4.1 Overview
- 4.2 Set Up a Wireless Network Using WPS
- 4.3 Connect to the Zyxel Device’s WiFi Network
- 4.4 Configure a Firewall Rule
- 4.5 Configure MAC Filter
- 4.6 Upgrade Firmware on the Zyxel Device
- 4.7 Back up a Configuration File
- 4.8 Restore Configuration
- 4.9 Configure DHCP
- 4.10 Configure Static Route for Routing to Another Network
- 4.11 Access the Zyxel Device Using DDNS
- Technical Reference
- Connection Status
- Broadband
- Home Networking
- Routing
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Firewall
- MAC Filter
- Certificates
- Log
- Traffic Status
- ARP Table
- Routing Table
- Cellular WAN Status
- System
- User Account
- Remote Management
- Time Settings
- E-mail Notification
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Diagnostic
- Troubleshooting
- Appendices
Chapter 4 Tutorials
LTE Series User’s Guide
42
• Select Destination IP Address: Enter the IP address of the computer to which traffic for the application
or service is entering.
• Protocol: Select the protocol (TCP, UDP or ICMP) used to transport the packets.
• Custom Source Port: Enter the port number/range of the source that define the traffic type.
• Custom Destination Port: Enter the port number/range of the destination that define the traffic type.
5 Select Enable Rate Limit to activate the rules you created. Click OK.
4.5 Configure MAC Filter
You can block certain web features and specific website addresses.
1 Go to the Configuration > Security > MAC Filter screen. Click Add New Rule.
2 Type the Host Name and the corresponding MAC Address that you want to block in the MAC Filter
screen.
3 Select the Active check box and click Apply.